LSI 3ware SAS 9750-8i Guida Utente Scaricare il pdf (Pagina 41)

www.lsi.com/channel/products 29

installation in. Chapter 2, “First-Time RAID Configuration Using 3BM.”

Additional information about configuration is also included in the later

chapters of this user guide.

If the operating system is already installed on another drive in your system,

you can configure units through 3BM, through 3ware Disk Manager (3DM 2),

or through the Command Line Interface (CLI). If you want to use 3DM 2 or

the CLI for configuration, go ahead and boot to the operating system, install

the driver and the 3DM 2 software, and then configure your units. You may

want to refer to the following information:

• Chapter 6, “3DM 2 (3ware Disk Manager) Introduction”

• Chapter 8, “Configuring Units”

• 3ware SATA+SAS RAID Controller Card CLI Guide, Version 10.0,

available from the 3ware CD and from the website

http://www.lsi.com/channel/ChannelDownloads

Install the Driver and Make the Operating System Aware

of the New Drives

Instructions for installing drivers are available in “Driver Installation” on

page 32.

You will also find instructions for updating the driver under “Downloading

the Driver and Firmware” on page 178.

Set Up Management and Maintenance Features

3ware RAID controllers include a number of features to help you manage and

maintain the controller and your configured units. The default settings for

these features allow you to begin using your newly configured units right

away. You can review and change these features as a final step in your initial

setup, or you can make changes to them later, at your convenience. These

features include:

• Controller and unit policies, such as Auto Rebuild, Auto Verify, use of

write cache, use of queuing mode, and selection of a StorSave profile.

• Email notification of alarms and other events

• Schedules for when background tasks will be performed, to minimize the

impact on day-to-day performance during peak usage times. (Background

tasks include rebuild, verify, initialize, migrate, and self-test.)

Details about these features are described in this documentation. When you

first set up your controller, you may want to review these sections in

particular:

• “Configuring Your Controller” on page 77

• “Setting Unit Policies” on page 107

• “Setting Background Task Rate” on page 168

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 341 342

Commenti su questo manuale

Vikivzn 04 Jan 2024 | 17:05:44

urenrjrjkvnm

Evazoy 07 Jan 2024 | 01:42:43

Med

Renatimzn 07 Jan 2024 | 09:55:43

urenrjrjkvnm

Davidvmm 10 Jan 2024 | 11:36:21

coin

Davidefb 11 Jan 2024 | 11:24:30

coin

Viktorijsw 11 Jan 2024 | 19:38:33

Cinema

LSI 3ware SAS 9750-8i Guida Utente Pagina 41

Commenti su questo manuale